Settings Calculator

Calculate optimal filter parameters for your tablet area and playstyle

SETTINGS CALCULATOR
Input
mm
×
mm
Parameters
4.0 px
6.0 px/ms
3.0 px/ms
0.50
4.0 ms
0.0 ms
0.8
0.75
LIVE PREVIEW
Net Speed 0.0 px/ms
Coherence 0.00
Dead Zone 4.0 px
State IDLE

Move your cursor over the canvas to see the filter in action. Hold still to watch chatter get suppressed; flick fast to watch the dead zone collapse to zero.

TUNING REFERENCE
→ More chatter?
Increase Max Dead Zone to 5–8 px
→ Slow aim feels sticky?
Decrease Max Dead Zone to 2–3 px
→ Jumps feel filtered?
Decrease Full Speed Threshold to 6–8 px/ms
→ Want snappier response?
Decrease Knee Speed to around a quarter of your Full Speed Threshold, or drop Zone At Knee Speed below 0.5 — the zone then collapses early instead of holding on into mid-speed movement
→ Streams get no smoothing at all, but raising the threshold over-smooths normal aim?
Raise Full Speed Threshold past your stream speed, then raise Knee Speed close behind it. Smoothing stays alive through fast movement while the mid range keeps only a fraction of the zone — one knob sets where the filter is fully out of the way, the other where it is still partly on
→ The knee is at the right speed but the amount there is wrong?
That is what Zone At Knee Speed is for. It sets how much of the dead zone survives at Knee Speed, as a fraction. 0.5 is a plain straight-ish fall-off; raise it towards 0.9 to keep almost the whole zone up to that speed and then drop it sharply, lower it towards 0.1 to shed most of the zone early and trail the rest off gently
→ Cursor lags behind?
Increase Lead towards 1.0 — it cancels the dead-zone offset on deliberate movement without letting chatter through
→ Dead zone reacts too slowly?
Decrease Velocity Smooth to 2–3 ms (below ~2 ms chatter starts leaking back in)
→ Coming from v1?
Your settings will not carry over, and Full Speed Threshold now wants roughly half its old value
QUICK INSTALL
OTD Repository Source
  1. Open OpenTabletDriver
  2. Go to Plugins → Open Plugin Manager
  3. Click the File → Use alternate source...
  4. Enter the values below and click Apply
Owner EncyOnCode CLICK TO COPY
Name VelocityGuard CLICK TO COPY
Ref main CLICK TO COPY